Hello, I found an error:
- Start Pixelmator Pro
- Open *.jpg
- click on “Text”
- Write a text, I used the font "Arial", but the error occurs with any other font.
- 1000 pixels so you can see the error better
- click on the text layer and add a new mask
- click on “Gradient Fill”.
- Now place the filling while holding down the mouse button. Now you will notice that this works very, very slowly and the colorful ball appears.
- If you convert the text layer to a pixel layer, the error does not occur, it only affects the vector layer
I use a Mac Mini with 16GB RAM and 512 SSD, it runs Ventura.
It would be nice if the error was corrected.
Best regards
Leif
Problem with text layers as vectors
2023-11-11 09:37:52
2023-11-11 18:01:07
@mccoytest
The problem is that you can only create a gradient very, very slowly.
If you try to adjust the course while holding down the mouse button (move the mouse left / right), then this runs in slow motion and the colorful ball appears. I have now also tested this under Sonoma, same result.
The problem is that you can only create a gradient very, very slowly.
If you try to adjust the course while holding down the mouse button (move the mouse left / right), then this runs in slow motion and the colorful ball appears. I have now also tested this under Sonoma, same result.
2023-11-12 19:09:13
The problem with “slow motion” may also occur here, but is not visible due to the better MAC!?
I help by converting to pixels but this is not a proper solution.
I help by converting to pixels but this is not a proper solution.