pixelmator and wood engraver

[DimDim]

Hello everyone,
I come to you because I cannot find a solution to my project.

I composed a 60X90 image on Pixelmator that I would like to divide/cut into 9 parts of 20X30.

The goal is to engrave each of the parts on a wooden board and assemble them like a puzzle

I can't find a tool that allows me to define an area of ​​this size and "extract" the image from it

Do you have any leads?

THANKS

[mccoytest]

One simple way would be to set a grid to divide the image into nine sections. Then use with the rectangular selection tool to get each individual area and ⌘C and ⌘V to create a new layer of each section then repeat 8 times for the other sections.

You could make guides and move them to the grid to simplify the selection.