Sooo, I have been using pixelmator pro to print tshirts with my designs.
I used a heat press and everything seemed like it went well. I even washed this shirt and the design came out intact.
Except for this stain, I have no idea how it got like that. I figured that if it was because of water, washing the tee would eff it up, but it didn't.
I think this happened after I washed my face while wearing it and some water fell on top of the design and maybe I should've wiped it off immediately??? idk...
So is there a way to fix or at least prevent this from happening?
Is there something i can press on top of my design to make sure it's "sealed"?
A place to talk about anything else with other Pixelmator users.
I'd go over the quick press for a heat press. It takes full pressure to make clothes with vinyl to make it stick and remain . In my view, you can just get the pressure the consumer puts on with the simple click at topvinylcutters.com, it is just a big hammer. I'd go for a minimum swing away heat press of 15'